Not applicable
Jul 03, 2013
06:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2013
06:19 AM
I may need to migrate my code and Apps from DAVE to Keil uVision 4 sometime in the future to allow me to look at code execution speeds in the Keil debugger.
I'm not entirely sure of the best way to do this without lots of trial and error. Is there a documented or recommended process to follow ?
I am using the xmc4500 device.
Any help and suggestions will be much appreciated.
Aaron
I'm not entirely sure of the best way to do this without lots of trial and error. Is there a documented or recommended process to follow ?
I am using the xmc4500 device.
Any help and suggestions will be much appreciated.
Aaron
- Tags:
- IFX
2 Replies
Not applicable
Jul 03, 2013
07:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2013
07:39 PM
Hi Aaron,
Yes, the relevant info is available in DAVE Support Portal http://www.infineon.com/cms/en/product/promopages/aim-mc/DAVE_3_Support_Portal/Third-Party-Support.h...
Best regards,
Sophia
Yes, the relevant info is available in DAVE Support Portal http://www.infineon.com/cms/en/product/promopages/aim-mc/DAVE_3_Support_Portal/Third-Party-Support.h...
Best regards,
Sophia
Not applicable
Jul 03, 2013
11:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2013
11:48 PM
Fantastic. Thank you yet again Sophia.
Best regards
Aaron
Best regards
Aaron