Aug 06, 2019
07:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 06, 2019
07:20 AM
I'm new to flash writing.
I've downloaded and installed Memtool V4.7.8 then noticed that "Program all" button is available in GUI.
What is the difference between "Program" and "Program all"?
I checked help in the tool, but the GUI shown in the help is old one.
There is no explanation about "Program all".
My team plans to automate flash writing by batch file, and the menu "Run batch" is available.
If we want to "Program all" in batch file, what command should be used in the batch file?
Is it like "program_all"?
Is there anybody who knows what kind of command is available in batch file for Memtool V4.7.8?
I've downloaded and installed Memtool V4.7.8 then noticed that "Program all" button is available in GUI.
What is the difference between "Program" and "Program all"?
I checked help in the tool, but the GUI shown in the help is old one.
There is no explanation about "Program all".
My team plans to automate flash writing by batch file, and the menu "Run batch" is available.
If we want to "Program all" in batch file, what command should be used in the batch file?
Is it like "program_all"?
Is there anybody who knows what kind of command is available in batch file for Memtool V4.7.8?
2 Replies
Aug 23, 2019
12:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 23, 2019
12:15 PM
Hey tomonori,
There's a thread over here that might help: https://www.infineonforums.com/threads/1141-memtool-jlink-batch-file?p=15266&viewfull=1#post15266
I've been looking for additional commands and ways to use the software from the command line without much success.
There's a thread over here that might help: https://www.infineonforums.com/threads/1141-memtool-jlink-batch-file?p=15266&viewfull=1#post15266
I've been looking for additional commands and ways to use the software from the command line without much success.
Sep 20, 2021
02:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2021
02:20 AM
Hi, is there a solution to erase, verify using the batch commands? As of now it seems stuck at only program syntax.
I’m trying to program, verify or erase using the batch commands for xc167ci-32F40 mcu. Can anyone help?
I’m trying to program, verify or erase using the batch commands for xc167ci-32F40 mcu. Can anyone help?