Jul 29, 2019
04:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2019
04:05 AM
Hello,
I would like to know if it's possible to configure the XMC4300 Ethercat Slave stack to work as an input only (end of the bus) ?
In the case of a star topology. The purpose to configure it this way would be to free some internal hardware ressources and some GPIO, peripheral, etc.
I would like to know if it's possible to configure the XMC4300 Ethercat Slave stack to work as an input only (end of the bus) ?
In the case of a star topology. The purpose to configure it this way would be to free some internal hardware ressources and some GPIO, peripheral, etc.
Labels
1 Reply
Attachments are accessible only for community members.
Aug 02, 2019
04:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 02, 2019
04:59 AM
Hi col265,
yes it is possible.
For reference see also hint inside ECAT_CM.H001 of errata sheet and chapter 16.3.1 of reference manual.
In addition you can also review the pdf attached to demonstrate a MAC2MAC connection where also the last device only used one port.
Kind Regards
Michael
yes it is possible.
For reference see also hint inside ECAT_CM.H001 of errata sheet and chapter 16.3.1 of reference manual.
In addition you can also review the pdf attached to demonstrate a MAC2MAC connection where also the last device only used one port.
Kind Regards
Michael