Jul 12, 2019
06:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2019
06:40 PM
I have a porblem about BTN8962,I use two 8962 to turn on a moto,firgue:
when i set in1=high,in2=low all inh =high ,but the moto not turn on ,whats the porblem?
when i set in1=high,in2=low all inh =high ,but the moto not turn on ,whats the porblem?
Labels
- Tags:
- IFX
5 Replies
Jul 12, 2019
07:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2019
07:01 PM
I use a mcu to control the moto ,and the high level is 3.3V,the datasheet show the input high level should above 1.75V,right?
Jul 12, 2019
07:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2019
07:15 PM
PIN 4 AND PIN 8 should connect togather?
Jul 13, 2019
08:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13, 2019
08:41 PM
OK,i think i find the false,the chip is dameged.
Jul 15, 2019
01:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 15, 2019
01:41 AM
Yes, should be above 1.75V
Jul 15, 2019
01:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 15, 2019
01:41 AM
Ok. Good Luck