May 27, 2019
01:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2019
01:10 AM
Hi,
I am using HighTec compiler to develop applications on top of TC297-B mircrocontroller. The problem I am facing is I am unable to activate core 1 or 2 from core 0. I used the following line to set core 1 or 2 CPUx_DBGSR.B.HALT=2; but corers are not activated. So could you please assist in what I am missing. Also, how to place conditions in startup code to activate the cores.
If any inputs on integration of FreeRTOS with TC297 will be helpful.
Many Thanks,
Kumaresh
I am using HighTec compiler to develop applications on top of TC297-B mircrocontroller. The problem I am facing is I am unable to activate core 1 or 2 from core 0. I used the following line to set core 1 or 2 CPUx_DBGSR.B.HALT=2; but corers are not activated. So could you please assist in what I am missing. Also, how to place conditions in startup code to activate the cores.
If any inputs on integration of FreeRTOS with TC297 will be helpful.
Many Thanks,
Kumaresh
1 Reply
Jun 12, 2019
02:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 12, 2019
02:48 AM
Hi Kumaresh,
If you are using IFX MCAL, I would recommend you to refer to the startup.c file.
This has the startup code for both single and multicore configurations.
Best Regards,
Sivakumar M.
If you are using IFX MCAL, I would recommend you to refer to the startup.c file.
This has the startup code for both single and multicore configurations.
Best Regards,
Sivakumar M.