Apr 24, 2019
01:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 24, 2019
01:05 AM
Hi,
I'm working with the TLE987x. I noticed that checking "TxD disconnected from integrated LIN-Trx"*box in Config Wizard UART1 setting disables P0.1 UART output (see screenshot attached).
This was tested using "UART1 send" uVision example project.
How to overcome this problem ?
I'm working with the TLE987x. I noticed that checking "TxD disconnected from integrated LIN-Trx"*box in Config Wizard UART1 setting disables P0.1 UART output (see screenshot attached).
This was tested using "UART1 send" uVision example project.
How to overcome this problem ?
Labels
1 Reply
Apr 24, 2019
01:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 24, 2019
01:07 AM
Hi,
It is not possible to send with P0.1 if you disconnect the LIN-TX from the UART1 TXD.
It is recommended to leave it connected and disable the LIN instead.
You can also set it to recieve only mode or sleep mode.
Best Regards,
It is not possible to send with P0.1 if you disconnect the LIN-TX from the UART1 TXD.
It is recommended to leave it connected and disable the LIN instead.
You can also set it to recieve only mode or sleep mode.
Best Regards,