Mar 28, 2019
08:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 28, 2019
08:54 PM
Hi,expert:
I am user of the evaluation board of Infineon" KIT_XMC48_RELAX_ECAT_V1" . When try to debug the board, a messsage popped "The selected device "unspecified" is unkown to this version of the J-LINK software......".
When I try to specify the MCU in segger j-link RDI,the software seem to need a license to get j-link RDI to set to the device"XMC4800".
Do I need to get a license for the J-LINK lite of the evaluation board?
Thanks ®ards.
I am user of the evaluation board of Infineon" KIT_XMC48_RELAX_ECAT_V1" . When try to debug the board, a messsage popped "The selected device "unspecified" is unkown to this version of the J-LINK software......".
When I try to specify the MCU in segger j-link RDI,the software seem to need a license to get j-link RDI to set to the device"XMC4800".
Do I need to get a license for the J-LINK lite of the evaluation board?
Thanks ®ards.
- Tags:
- IFX
2 Replies
Apr 02, 2019
05:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 02, 2019
05:23 AM
Hi,
Could you show your debug configuration as below?
Regards,
Jesus
Could you show your debug configuration as below?
Regards,
Jesus
Apr 09, 2019
07:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 09, 2019
07:39 PM
Thank you ,sir.
The problem solved when I set the j-link gdbservercl rightly.
The problem solved when I set the j-link gdbservercl rightly.