SMU configuration problem

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
User16497
Level 1
Level 1
Hi,

I am trying to configure the SMU using FSP. Whenever I tried to release the FPS using the CMD and ARG, the result of that command is "command failed". I assumed that the SMU is in alert state at startup and that therefore, It should be set to non-failure state to be condifurable and to set the alarms.

Before that configuration attempt, I
- enabled the watchdog timers,
- enabled ENDINIT and safety ENDNITIT
- set the SMU's keys
- configured the Port control registers HWDIR, HWEN and the PCS to 1
- and, the FSP pin as bi-stable protocol.

Do you know If I missed some step?

Thanks in advance,

Asier
0 Likes
1 Reply
MoD
Employee
Employee
50 likes received 500 replies posted 100 solutions authored
ReleaseFSP is only a vaild command if the SMU is in START or FAULT state. I expect that you are in RUN state and therefore the command failed.
0 Likes