Feb 23, 2019
03:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 23, 2019
03:46 PM
Hello,
I would like to use an infineon 600 V Power MOSFET for building up a high voltage test equipment. If the continuous drain current (Id) rating of the switch is given as 30 A in the datasheet, can the MOSFET withstand a surge of 500 A for a few millisecond range?
Best Regards,
Gets
I would like to use an infineon 600 V Power MOSFET for building up a high voltage test equipment. If the continuous drain current (Id) rating of the switch is given as 30 A in the datasheet, can the MOSFET withstand a surge of 500 A for a few millisecond range?
Best Regards,
Gets
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Feb 24, 2019
09:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 24, 2019
09:32 PM
Hello Gets,
There is a parameter -- Id,pulse on the datasheet, please refer to the specific datasheet for this case.
Regards,
Daisy
There is a parameter -- Id,pulse on the datasheet, please refer to the specific datasheet for this case.
Regards,
Daisy
1 Reply
Feb 24, 2019
09:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 24, 2019
09:32 PM
Hello Gets,
There is a parameter -- Id,pulse on the datasheet, please refer to the specific datasheet for this case.
Regards,
Daisy
There is a parameter -- Id,pulse on the datasheet, please refer to the specific datasheet for this case.
Regards,
Daisy