Feb 02, 2019
08:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 02, 2019
08:53 AM
Just a note for other users, I recently changed from using an IRS2110 (lower floating voltage version) and encountered a persistent fault in an H-bridge
where it looked like high side UVLO (the high side just stopped working) even though the low side continued working. I spent ages scoping the high side
and changing components in the boost circuit to no avail. Eventually in desperation I grounded the previously floating Sd pin and the fault went away!
I should emphasize this was a swap from an IRS2110 to an IRS2113 in the same pcb in a previously working circuit. Both date codes concerned 713P
so it seems maybe I was lucky before or the 2113 is more sensitive, in either case I would never rely on the internal pulldowns again.
Has this site never heard of an editor that wraps!
where it looked like high side UVLO (the high side just stopped working) even though the low side continued working. I spent ages scoping the high side
and changing components in the boost circuit to no avail. Eventually in desperation I grounded the previously floating Sd pin and the fault went away!
I should emphasize this was a swap from an IRS2110 to an IRS2113 in the same pcb in a previously working circuit. Both date codes concerned 713P
so it seems maybe I was lucky before or the 2113 is more sensitive, in either case I would never rely on the internal pulldowns again.
Has this site never heard of an editor that wraps!
Solved! Go to Solution.
Labels
1 Solution
Feb 23, 2022
09:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 23, 2022
09:20 PM
Hi,
Even though data sheet says grounding is unnecessary but in your case, due to near by signals it would be catching some noise .So, I request you to make it solid ground and test once more.
BR,
AZIZ HASSAN
3 Replies
Feb 04, 2019
01:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 04, 2019
01:08 PM
What is the VDD and VCC voltage in your design?
The Sd pin has a weak pull down internally. It is recommended to ground the pin if unused.
The Sd pin has a weak pull down internally. It is recommended to ground the pin if unused.
Feb 08, 2019
03:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 08, 2019
03:41 AM
Hello, my VCC is 12V & VDD is 3V3.
Unfortunately the data sheet implies grounding is unnecessary and I think I left it floating for future use however on closer inspection of the data sheet it seems the pulldown resistance is undefined! At best there is a TYPICAL value for input leakage but no minimum.....
Unfortunately the data sheet implies grounding is unnecessary and I think I left it floating for future use however on closer inspection of the data sheet it seems the pulldown resistance is undefined! At best there is a TYPICAL value for input leakage but no minimum.....
Feb 23, 2022
09:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 23, 2022
09:20 PM
Hi,
Even though data sheet says grounding is unnecessary but in your case, due to near by signals it would be catching some noise .So, I request you to make it solid ground and test once more.
BR,
AZIZ HASSAN