Jan 28, 2019
10:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 28, 2019
10:38 PM
Hello All,
I am trying to create a custom made board using a XMC1100 chip and ESP32. The XMC1100 boot kit has a XMC4200 as USB-Serial bridge and Hardware debugger. I want to remove that. My idea has been to put the bootloader code inside flash of XMC1100 itself and not use 4200 for that. I am looking out for the viability of this idea and how to do that! Also I am pretty convinced that there's more inside of 4200 than just a bootloader code like linker scripts and startup codes etc.
Any help would be appreciated , Thanks!
I am trying to create a custom made board using a XMC1100 chip and ESP32. The XMC1100 boot kit has a XMC4200 as USB-Serial bridge and Hardware debugger. I want to remove that. My idea has been to put the bootloader code inside flash of XMC1100 itself and not use 4200 for that. I am looking out for the viability of this idea and how to do that! Also I am pretty convinced that there's more inside of 4200 than just a bootloader code like linker scripts and startup codes etc.
Any help would be appreciated , Thanks!
1 Reply
Jan 29, 2019
05:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 29, 2019
05:03 AM
Hello Yash,
have a look to: https://www.feaser.com/openblt/doku.php?id=homepage
this is a good bootloader for XMC´s. You will only need 2 pins (UART).
Best regards
Andreas
have a look to: https://www.feaser.com/openblt/doku.php?id=homepage
this is a good bootloader for XMC´s. You will only need 2 pins (UART).
Best regards
Andreas