Jan 14, 2019
04:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2019
04:45 AM
Hi
I just changed my PC with a new Windows version.
I installed uVision and JLINK software 6.40
debugger : Segger JLink LiteCortexM-5V
But when I try to flash, the device is telling me:
I uninstalled the Jlink 6.4 and downloaded the 6.32, but the uVision is still showing the same problem
At the beginning I was able to program the ePower
Then suddenly, I got this error (maybe I’ve updated something?)
Thanks a lot for your answer.
I just changed my PC with a new Windows version.
I installed uVision and JLINK software 6.40
debugger : Segger JLink LiteCortexM-5V
But when I try to flash, the device is telling me:
I uninstalled the Jlink 6.4 and downloaded the 6.32, but the uVision is still showing the same problem
At the beginning I was able to program the ePower
Then suddenly, I got this error (maybe I’ve updated something?)
Thanks a lot for your answer.
1 Reply
Jan 14, 2019
04:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2019
04:49 AM
Dear ePowerForever,
Please try again with the version 6.34h of the Segger JLink Driver. Before downgrading the JLink driver, you should close all running uVision instances.
Best Regards,
pestadieu
Please try again with the version 6.34h of the Segger JLink Driver. Before downgrading the JLink driver, you should close all running uVision instances.
Best Regards,
pestadieu