Dec 05, 2018
12:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 05, 2018
12:51 AM
Hello everyone,
I have been working through the tutorial using DAVE software described in this document:
https://www.infineon.com/dgdl/Infineon-Application_Lighting_Digital_Multiplex_(DMX512)_Receiving_Dev...
I am able to get the 3-Channel RGB DMX program to work, however, I am struggling with the 4-channel.
What I do is change the number of channels to 4 under the PDM_DIMMED_LED_LAMP settings, then choose an unused pin for my new LED that corresponds to one of the colours on LEDs 2 and 3.
Then I update the number of relevant slots in the DMX512_RD_0 from 3 to 4, then update the code for an extra LED.
However, when I do all of this, then build and run the code, it compiles and debugs fine, but none of the LEDs turn on.
If anyone has a solution for this, I would be very thankful.
I have been working through the tutorial using DAVE software described in this document:
https://www.infineon.com/dgdl/Infineon-Application_Lighting_Digital_Multiplex_(DMX512)_Receiving_Dev...
I am able to get the 3-Channel RGB DMX program to work, however, I am struggling with the 4-channel.
What I do is change the number of channels to 4 under the PDM_DIMMED_LED_LAMP settings, then choose an unused pin for my new LED that corresponds to one of the colours on LEDs 2 and 3.
Then I update the number of relevant slots in the DMX512_RD_0 from 3 to 4, then update the code for an extra LED.
However, when I do all of this, then build and run the code, it compiles and debugs fine, but none of the LEDs turn on.
If anyone has a solution for this, I would be very thankful.
Labels
0 Replies