Nov 02, 2018
05:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 02, 2018
05:51 AM
Hi, i'm facing the problem with this board. I have connected XMC1100 Kit(for Arduino) to W5500 Ehernet Board(1471-1413-ND) via SPI. When communication starts, all is so slow. I mean data transfer is slower than i expected. I seems SPI bus has a lot of errors or something. When i touch osciloscope probe to CLK pin then communication stops. I see in my debug console just ,,disconnected,, and board needs reset to start communication again. When i switched to Arduino UNO(Circuit stayed the same. Sketch stayed the same. Web Server sketch from Ethernet 2 library.) its works perfectly. Datasheet says: fully compatible with Arduino. So please where is the problem ? Thanks
- Tags:
- IFX
1 Reply
Nov 05, 2018
05:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 05, 2018
05:31 AM