Oct 22, 2018
08:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 22, 2018
08:44 AM
I have XMC1100 2Go and Presureshild 2go, 3D Megnetic sensor shield 2go and current sensor 2go, I want to connect it so I looked through the getting started guide of the sensor shileds. There I find the image
I doubt is it a right way? Cause if I connect as shown in the figure the correcponding pins will not match. Vss on XMC will connect with GND of pressure shild and CSBN with VDD and so on...
I doubt is it a right way? Cause if I connect as shown in the figure the correcponding pins will not match. Vss on XMC will connect with GND of pressure shild and CSBN with VDD and so on...
0 Replies