Sep 11, 2018
09:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 11, 2018
09:39 AM
We're using the TLE7242 to drive a solenoid load as part of our test system. We're sending a ramp signal: 0 to 1000 to 0 milliAmps with 50 milliAmps steps and each step timed for 100 milliSecond.
We have a current sense circuit inline with the solenoid for realtime readings. However, we're getting a variation in the sensed current readings when we repeatedly apply our ramp signal.
Is there a specific order in which messages have to be sent to the chip to get it to drive the load? Is steady-state mode (feedback) automatically on?
Thank you for your help,
Ron
We have a current sense circuit inline with the solenoid for realtime readings. However, we're getting a variation in the sensed current readings when we repeatedly apply our ramp signal.
Is there a specific order in which messages have to be sent to the chip to get it to drive the load? Is steady-state mode (feedback) automatically on?
Thank you for your help,
Ron
0 Replies