Not applicable
Aug 09, 2018
07:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 09, 2018
07:09 AM
Hello,
I can only program my board by USB, but I want to use Jlink because I already have the power on board.
In this board there is 2 processors and one for debug, may be it keep priority on debug.
So I connect it on the connector X5 but when I run the debug on DAVE, an error appear.
Connecting to J-Link...
J-Link is connected.
Firmware: J-Link V10 compiled Jul 23 2018 09:53:14
Hardware: V10.10
S/N: 50111665
Feature(s): GDB
Checking target voltage...
Target voltage: 3.04 V
Listening on TCP/IP port 2331
Connecting to target...ERROR: Could not find core in Coresight setup
ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
Could not connect to target.
Please check power, connection and settings.
I run Jlink.exe and try connected by connect
But still don't work.
If someone have an answer! Thank you.
I can only program my board by USB, but I want to use Jlink because I already have the power on board.
In this board there is 2 processors and one for debug, may be it keep priority on debug.
So I connect it on the connector X5 but when I run the debug on DAVE, an error appear.
Connecting to J-Link...
J-Link is connected.
Firmware: J-Link V10 compiled Jul 23 2018 09:53:14
Hardware: V10.10
S/N: 50111665
Feature(s): GDB
Checking target voltage...
Target voltage: 3.04 V
Listening on TCP/IP port 2331
Connecting to target...ERROR: Could not find core in Coresight setup
ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
Could not connect to target.
Please check power, connection and settings.
I run Jlink.exe and try connected by connect
But still don't work.
If someone have an answer! Thank you.
1 Reply
Aug 15, 2018
07:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 15, 2018
07:21 PM
MilouT wrote:
Hello,
I can only program my board by USB, but I want to use Jlink because I already have the power on board.
In this board there is 2 processors and one for debug, may be it keep priority on debug.
So I connect it on the connector X5 but when I run the debug on DAVE, an error appear.
Connecting to J-Link...
J-Link is connected.
Firmware: J-Link V10 compiled Jul 23 2018 09:53:14
Hardware: V10.10
S/N: 50111665
Feature(s): GDB
Checking target voltage...
Target voltage: 3.04 V
Listening on TCP/IP port 2331
Connecting to target...ERROR: Could not find core in Coresight setup
ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
Could not connect to target.
Please check power, connection and settings.
I run Jlink.exe and try connected by connect
But still don't work.
If someone have an answer! Thank you.
Hi Milou T,
Do you have solved it?I have some related questions.
But I can debug it by SWD, not JTAG.
I think that The TRST Pin must need pull up.