Not applicable
May 11, 2018
07:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 11, 2018
07:26 AM
Hi
I would like to establish a wireless communication with a receiver.
For this I use Biphase Mark. (at 1 half duty cycle else full duty cycle)
An XMC1100 should use the Buck Converter to model the signal.
This signal is 11 bits long and I'm not sure how I can transmit the signal with a frequency of 2kHz.
I would like to establish a wireless communication with a receiver.
For this I use Biphase Mark. (at 1 half duty cycle else full duty cycle)
An XMC1100 should use the Buck Converter to model the signal.
This signal is 11 bits long and I'm not sure how I can transmit the signal with a frequency of 2kHz.
0 Replies