Hi.
I am unable to connect the output ST of a CCU4_SLICE_CONFIG_x to "event_in0" input of another CCU4 SLICE_CONFIG_y.
I am using the HW Signal Connectios window, selcting CCU4_SLICE_CONFIG_x--> source Signal (ST),
connect to --> CCU4_SLICE_CONFIG_y, but in the Target Signal menu, it only appers in0, in1 and in2. However I expected to see in the
Target Signal menu, the "event_in0" that I create in the CCU4_SLICE_CONFIG_y and that already I can see in the HW Signal Connectivity.
Can anyone tell where is my mistake?
I would like to connect CCU4_SLICE_CONFIG_x-->ST, to CCU4_SLICE_CONFIG_y-->event_in0 to Start the timing of CCU4_SLICE_CONFIG_y.
Best regards.
Carlos.
