Not applicable
Apr 10, 2018
06:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 10, 2018
06:55 AM
Dear all,
I am finding it difficult to measure the voltage in ADC1 Ch1(Opamp) in TLE9879.
I have configured the EIM mode for ADC1 Ch1 Triggered by GPT12E_T6 as shown in the figure below.
But I always see nearly a constant digital value(29,34,29,29,34............so on).
Interestingly, when I check the same with the Channel4(P2.4) with the potentiometer, it works fine.
Please suggest...! Thanks.
Reg
Litun
I am finding it difficult to measure the voltage in ADC1 Ch1(Opamp) in TLE9879.
I have configured the EIM mode for ADC1 Ch1 Triggered by GPT12E_T6 as shown in the figure below.
But I always see nearly a constant digital value(29,34,29,29,34............so on).
Interestingly, when I check the same with the Channel4(P2.4) with the potentiometer, it works fine.
Please suggest...! Thanks.
Reg
Litun
Labels
2 Replies
Not applicable
Apr 17, 2018
12:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 17, 2018
12:54 AM
Got it. Chip CSA peripheral is dead. 😞
May 29, 2023
11:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 29, 2023
11:08 PM
Hello. Did you get any success on other uC?