[SOLVED] ADC1 Ch1 measurement in TLE9879

Announcements

Webinar: Integrated solutions for smaller, simpler low-voltage motor control design.
Join the webinar to experience!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Dear all,
I am finding it difficult to measure the voltage in ADC1 Ch1(Opamp) in TLE9879.

I have configured the EIM mode for ADC1 Ch1 Triggered by GPT12E_T6 as shown in the figure below.
3059.attach

But I always see nearly a constant digital value(29,34,29,29,34............so on).

Interestingly, when I check the same with the Channel4(P2.4) with the potentiometer, it works fine.

Please suggest...! Thanks.


Reg
Litun
0 Likes
2 Replies
Not applicable
Got it. Chip CSA peripheral is dead. 😞
0 Likes
AmolKoli
Level 4
Level 4
First solution authored 10 questions asked 50 sign-ins

Hello. Did you get any success on other uC?

0 Likes