Debug error help

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
When trying to run a sample code for the 24v shield I keep getting the following

Error in services launch sequence
Launching command [/JLinkGDBServerCL.exe -if swd -device XMC1100-T038x0064 -endian little -speed auto -port 2331 -swoport 2332 -telnetport 2333 -vd -ir -localhostonly 1 -singlerun -strict -timeout 0] failed.
Launching command [/JLinkGDBServerCL.exe -if swd -device XMC1100-T038x0064 -endian little -speed auto -port 2331 -swoport 2332 -telnetport 2333 -vd -ir -localhostonly 1 -singlerun -strict -timeout 0] failed.
Cannot run program "/JLinkGDBServerCL.exe": Launching failed

When debugging it.

Following the steps for setup from this page
https://www.infineon.com/dgdl/Infineon-24V_ProtectedSwitchShield_with_Profet+24V_for_Arduino_UsersMa...

Any help would be greatly appreciated.
0 Likes
1 Reply
Andi_H
Employee
Employee
First solution authored First like received
Hello,

See if the correct path is set (newes J-Link Software)

3056.attach

best regards
Andreas H.
0 Likes