Feb 06, 2018
06:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 06, 2018
06:24 AM
Hi All,
I am trying to get deeper in the FOC library. It seems that this library is really powerful, but I am figthing with a strange problem.
I have linked the PMSM_FOC_O.user_speed_set to a numeric box (I have also tried with a slider) in the Micrium program, in order to have a graphic interface where I can modify the motor speed in debug mode,
The control works uncorrectly: it only INCREASES the speed. When I try to reduce the value, the control does not change the motor speed.
Any idea or suggestion?
Thank you very much
Best Regards
Ciao
Fabio
I am trying to get deeper in the FOC library. It seems that this library is really powerful, but I am figthing with a strange problem.
I have linked the PMSM_FOC_O.user_speed_set to a numeric box (I have also tried with a slider) in the Micrium program, in order to have a graphic interface where I can modify the motor speed in debug mode,
The control works uncorrectly: it only INCREASES the speed. When I try to reduce the value, the control does not change the motor speed.
Any idea or suggestion?
Thank you very much
Best Regards
Ciao
Fabio
0 Replies