Not applicable
Jan 12, 2018
04:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 12, 2018
04:26 PM
Dear all,
for the Relax Kits V1 , there is no additional programmer needed.
It seams that the XMC4800 Automation Board V2 , has not such a USB programming port.
Where to find an programmer wit conetion cable that fits to the board ?
I wan't to use it with "Dave IDE".
Thanks in advance !
Marc
for the Relax Kits V1 , there is no additional programmer needed.
It seams that the XMC4800 Automation Board V2 , has not such a USB programming port.
Where to find an programmer wit conetion cable that fits to the board ?
I wan't to use it with "Dave IDE".
Thanks in advance !
Marc
- Tags:
- IFX
1 Reply
Jan 13, 2018
02:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2018
02:56 AM
HI Marc,
to quote User Manual: "The XMC4800 Automation Board-V2 supports debugging via a 10-pin Cortex™ Debug Connector. To program and debug the chip any standard ARM™ debugger can be used." Example of those kind of devices are XMC Link or Keil uLink products. Just make sure you see that it connects via a 10-pin Cortex™ Debug Connector.
Regards,
Deni
to quote User Manual: "The XMC4800 Automation Board-V2 supports debugging via a 10-pin Cortex™ Debug Connector. To program and debug the chip any standard ARM™ debugger can be used." Example of those kind of devices are XMC Link or Keil uLink products. Just make sure you see that it connects via a 10-pin Cortex™ Debug Connector.
Regards,
Deni