Jan 12, 2018
08:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 12, 2018
08:54 AM
Hallo,
I have just bought the new EVAL-M1-CM610N3 power board equipped with the CIPOS mini IKCM10L60GA, to be tested with the Eval M1-1302, the control board with XMC1302.
I have tried to find some examples for this board, but I couldn't find any solution.
We are developing a new BLDC motor for sanding tools, and we would like to test your FOC solution.
Do I have to follow different configurations?
Thank you very much for your help
BR
Fabio
I have just bought the new EVAL-M1-CM610N3 power board equipped with the CIPOS mini IKCM10L60GA, to be tested with the Eval M1-1302, the control board with XMC1302.
I have tried to find some examples for this board, but I couldn't find any solution.
We are developing a new BLDC motor for sanding tools, and we would like to test your FOC solution.
Do I have to follow different configurations?
Thank you very much for your help
BR
Fabio
1 Reply
Feb 06, 2018
06:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 06, 2018
06:27 AM
Hi All,
I have used the FOC library setting the right parameters in the Power Board settings.
I can issue more infos if needed.
Ciao
F
I have used the FOC library setting the right parameters in the Power Board settings.
I can issue more infos if needed.
Ciao
F