Dec 05, 2017
11:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 05, 2017
11:11 AM
Hi,
i use XMC1100-T038X0064.
the first uart works perfect, Standard pins used: P1.2 and P1.3
now i would like to setup a second UART on Pins P1.0 and P1.1. Up to this moment they are free, not used by something else.
when i try to add a new APP, Communication, General Purpose, UART, Dave (V4.3.2) is not able to grant my last resources request.
what might go wrong? Who has an idea? Thanks in advance!
i use XMC1100-T038X0064.
the first uart works perfect, Standard pins used: P1.2 and P1.3
now i would like to setup a second UART on Pins P1.0 and P1.1. Up to this moment they are free, not used by something else.
when i try to add a new APP, Communication, General Purpose, UART, Dave (V4.3.2) is not able to grant my last resources request.
what might go wrong? Who has an idea? Thanks in advance!
1 Reply
Jan 03, 2018
03:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 03, 2018
03:14 AM
Hy WS123,
did you use the "Pin Out Tool" ? It is good for the PIN allocation before start with Dave...
https://www.infineon.com/cms/de/product/microcontroller/32-bit-industrial-microcontroller-based-on-a...
I have tested with a blank dave project and only this 2 UART Apps without problems... it looks like that any other app cause the problem!?
which apps do you use?
best regards
Andi
did you use the "Pin Out Tool" ? It is good for the PIN allocation before start with Dave...
https://www.infineon.com/cms/de/product/microcontroller/32-bit-industrial-microcontroller-based-on-a...
I have tested with a blank dave project and only this 2 UART Apps without problems... it looks like that any other app cause the problem!?
which apps do you use?
best regards
Andi