Not applicable
Nov 10, 2017
06:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2017
06:06 AM
I am using XMC4500 Relax Lite Kit for my 1st LED Blinking model using matlab 2016a.
As shown in figure attached, I am trying to glow LED1 (on P1.1) using SW at 1 second rate and LED2 (on port P1.0) using SW at 2 second rate.
I have configured these ports in GPIO-Config as Output Port using SW. And, ports are configured as Control-Via-Input using GPIO-Digital-Write
But, I don't see the LED blinking. Am I missing something here.
Appreciate for quick help.
As shown in figure attached, I am trying to glow LED1 (on P1.1) using SW at 1 second rate and LED2 (on port P1.0) using SW at 2 second rate.
I have configured these ports in GPIO-Config as Output Port using SW. And, ports are configured as Control-Via-Input using GPIO-Digital-Write
But, I don't see the LED blinking. Am I missing something here.
Appreciate for quick help.
1 Reply
Not applicable
Nov 18, 2017
10:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2017
10:02 PM
I am not sure, but it seems that Matlab don't have working code for the 'Systimer' block.
Any help on the original question is appreciated!
Any help on the original question is appreciated!