Not applicable
Nov 03, 2017
10:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 03, 2017
10:37 AM
Hello
I have a Problem with DAVE 4
I Used to setup a Timerfunction. I have read the manual and there is written i need to use the ISR together with the Timer (CCU4).
And this way i need to couple those Signals to trigger a Interrupt when the timer has finished its job. (All things according to the Manual)
I done it stepp by step but now im stuck--> The HW Signal Connection cant be set and i dont know how to fix that.
Here is a Picture of the HW Signal Connections
Can Someone Help me?
I have a Problem with DAVE 4
I Used to setup a Timerfunction. I have read the manual and there is written i need to use the ISR together with the Timer (CCU4).
And this way i need to couple those Signals to trigger a Interrupt when the timer has finished its job. (All things according to the Manual)
I done it stepp by step but now im stuck--> The HW Signal Connection cant be set and i dont know how to fix that.
Here is a Picture of the HW Signal Connections
Can Someone Help me?
1 Reply
Nov 06, 2017
11:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 06, 2017
11:32 PM
Hi,
You need to enable the timer interval event in the Event Settings tab
Regards,
Jesus
You need to enable the timer interval event in the Event Settings tab
Regards,
Jesus