Not applicable
Oct 23, 2017
12:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2017
12:46 AM
Hello,
i need program an micro TC264DE with the DAP mini wiggler, but i don't find the target configuration file (.cfg).
Which file cfg i need use?
Also i program by JTAG connector but i don't know how configure Memtool 4.7, can you help me please?
Best regards
i need program an micro TC264DE with the DAP mini wiggler, but i don't find the target configuration file (.cfg).
Which file cfg i need use?
Also i program by JTAG connector but i don't know how configure Memtool 4.7, can you help me please?
Best regards
Labels
- Tags:
- IFX
2 Replies
Oct 29, 2017
11:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 29, 2017
11:21 AM
You should start from the default configuration for Appkit/Triboard.
In most situation, you don't need to write a new configuration from scratch.
In most situation, you don't need to write a new configuration from scratch.
Apr 12, 2024
01:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 12, 2024
01:24 PM
- Begin by ensuring that you have the necessary hardware components, including the DAP miniwiggler and TC264DE microcontroller.
- Connect the DAP miniwiggler to your computer using a USB cable and ensure that it is properly recognized by the operating system.
- Locate the JTAG connector on the TC264DE microcontroller board and connect it to the corresponding connector on the DAP miniwiggler.
- Double-check the connection between the miniwiggler and the microcontroller to ensure it is secure and aligned correctly.
- Install the appropriate device drivers for the DAP miniwiggler on your computer to enable communication with the microcontroller.
- Open your preferred Integrated Development Environment (IDE) for TC264DE programming, such as Tasking or Eclipse.
- Configure the IDE to recognize the DAP miniwiggler as the debugging interface for the TC264DE microcontroller.
- Create or open a project in the IDE that targets the TC264DE microcontroller and set up the necessary build configurations.
- Configure the debugging settings in the IDE to use the DAP miniwiggler as the debug probe for the TC264DE microcontroller.
- Build your project and load the generated binary onto the TC264DE microcontroller using the DAP miniwiggler for programming and debugging.
- Use the debugging features provided by the IDE to interactively debug and test your application running on the TC264DE microcontroller.
- Refer to the datasheets, user manuals, and application notes provided by Pdf resources for further guidance and troubleshooting tips on using the DAP miniwiggler with the TC264DE microcontroller effectively.