Not applicable
Sep 21, 2017
11:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 21, 2017
11:32 PM
Hello,
I am trying to setup a half bridge simulation with IR 2113 and IPx60R125 devices.
I have a boot strap circuit and have also charged the capacitor by giving pulse to low side switch first.
The simulation however fails with overflow and convert error. This error happens right at the beginning of the simulation.
I am unable to understand what is happening and would want some pointers and help to fix this issue.
I greatly appreciate any help.
I am trying to setup a half bridge simulation with IR 2113 and IPx60R125 devices.
I have a boot strap circuit and have also charged the capacitor by giving pulse to low side switch first.
The simulation however fails with overflow and convert error. This error happens right at the beginning of the simulation.
I am unable to understand what is happening and would want some pointers and help to fix this issue.
I greatly appreciate any help.
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Nov 02, 2020
11:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 02, 2020
11:32 AM
Same problem here with IR2110, overflow error with pspice & cadence... I tried a lot of tweak but nothing work 😞 Do you have found a solution ? Thanks !
2 Replies
Sep 25, 2017
05:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 25, 2017
05:20 AM
The models for Infineon Power MOSFET are evaluated with SIMetrixTM-PSpice simulator.
The Infineon Power MOSFET models are tested, verified and provided in PSpice simulation code.
For the MOSFET please consult the following application note providing Information about the Simulation model: Application Note Introduction to Infineons Simulation Models for Power MOSFETs.
You should add your circuitry and the error report of your simulation about overflow and convert error to your post.
The Infineon Power MOSFET models are tested, verified and provided in PSpice simulation code.
For the MOSFET please consult the following application note providing Information about the Simulation model: Application Note Introduction to Infineons Simulation Models for Power MOSFETs.
You should add your circuitry and the error report of your simulation about overflow and convert error to your post.
Nov 02, 2020
11:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 02, 2020
11:32 AM
Same problem here with IR2110, overflow error with pspice & cadence... I tried a lot of tweak but nothing work 😞 Do you have found a solution ? Thanks !