Not applicable
Sep 20, 2017
08:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2017
08:37 AM
Hello,
For one of the extensions to an existing design, I thought of adding clamps to the following question using general purpose diodes. Does this look right?
I wasn’t sure if one needs a current limiting resistor i.e. say if this isn’t an application where power dissipation is of primal importance. In this regard, can you get away without a current limiting resistor (to preserve impedance of source)?
Thanks.
For one of the extensions to an existing design, I thought of adding clamps to the following question using general purpose diodes. Does this look right?
I wasn’t sure if one needs a current limiting resistor i.e. say if this isn’t an application where power dissipation is of primal importance. In this regard, can you get away without a current limiting resistor (to preserve impedance of source)?
Thanks.
Labels
- Labels:
-
ESD Protection Forum
0 Replies