Jul 27, 2017
11:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2017
11:05 PM
There is a Special Micrium µc/Probe Version for Infineon XMC microcontrollers, which is free.
I have some Support questions, but Micrium say they cannot Support me, because I am using the free Infineon Version. They say I have to contact Infineon for Support. The Problem is I cannot find any Support on the Infineon
Website.
Where can I get Support?
I have some Support questions, but Micrium say they cannot Support me, because I am using the free Infineon Version. They say I have to contact Infineon for Support. The Problem is I cannot find any Support on the Infineon
Website.
Where can I get Support?
2 Replies
Aug 16, 2017
02:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 16, 2017
02:51 AM
Hi,
What are your questions about uC/Probe?
Regards,
Jesus
What are your questions about uC/Probe?
Regards,
Jesus
Aug 16, 2017
04:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 16, 2017
04:46 AM
The main issue I was having has been fixed by Micrium in the meantime. The program would hang and then report an Out of Memory Error after about 15 minutes.
Micrium sent me a link to a newer version which fixed this problem.
The next big problem is that I use the Keil ULINKpro debugger, which is not supported by the free inifeon version of the program.
This seems a bit strange as the Infineon hexagon evaluation board has the 10 and 20 pin ULINK connector.
Micrium sent me a link to a newer version which fixed this problem.
The next big problem is that I use the Keil ULINKpro debugger, which is not supported by the free inifeon version of the program.
This seems a bit strange as the Infineon hexagon evaluation board has the 10 and 20 pin ULINK connector.