Not applicable
Jun 21, 2017
02:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 21, 2017
02:05 AM
I have a simple robot with two DC motors. Using the L298N Dual H-Bridge, what's the minimum number of control pins I can use to give me forward, back and turn?
Here is the date sheet of l298n
Here's a typical setup for the chip. It looks like I'll need 6 control lines to control 2 motors.
If I tied Ven high and relied on the "C=D Fast Motor Stop" when idle would this be bad?
Here is the date sheet of l298n
Here's a typical setup for the chip. It looks like I'll need 6 control lines to control 2 motors.
If I tied Ven high and relied on the "C=D Fast Motor Stop" when idle would this be bad?
0 Replies