Not applicable
Jun 15, 2017
06:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2017
06:55 AM
Hello,
Now I am trying to use the two USIC channel in XMC1100 to test the SPI communication. I used the dave app to
generate the code automatically. Now I could see the master could send the message out but the slave seems not
to work. The example code only provides the master loopback application and it works fine.
Then I enable the Slave select input event callback to test weather the salve could receive the slave select input signal
but it seems no such input signal. I am stuck by this problem several days.
Is there anyone who has met the similar problem? I found these two channels are in the same silence, can this be the
main problem? please help me, thanks!
Best regards,
Ziming Lu
Now I am trying to use the two USIC channel in XMC1100 to test the SPI communication. I used the dave app to
generate the code automatically. Now I could see the master could send the message out but the slave seems not
to work. The example code only provides the master loopback application and it works fine.
Then I enable the Slave select input event callback to test weather the salve could receive the slave select input signal
but it seems no such input signal. I am stuck by this problem several days.
Is there anyone who has met the similar problem? I found these two channels are in the same silence, can this be the
main problem? please help me, thanks!
Best regards,
Ziming Lu
- Tags:
- IFX
0 Replies