TC1797 UDE-DAS Problem

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Hi everyone,

I'm new in Infineon and this forum. I started to work on TC1797 Tricore with DAVE 2. I watched a video which explain to start coding with DAVE in here; http://www.edge-cdn.net/index.php?ct=1353&vid=140502&setlang=en

I did all steps in the video but in UDE section, my compile process failed and I met this error ;

WARNING: Controller0.Core::UDEMemtool: FLASH programming for device '2 MByte OnChip Program FLASH (Demo)' not available !
ERROR: Controller0.Core::PFLASH1: Initializing FLASH driver on target failed
WARNING: Controller0.Core::UDEMemtool: FLASH programming for device '2 MByte OnChip Program FLASH (2) (Demo)' not available !
ERROR: Controller0.Core::FLASH: Initializing FLASH driver on target failed
WARNING: Controller0.Core::UDEMemtool: FLASH programming for device '64 KByte OnChip Data FLASH (Demo)' not available !
MSG: Controller0.Core::UDEDebugServer: Connection to TC1797 target monitor established: TriCore (Core), ID: 1015A083h
WARNING: Controller0.Core::UDEDebugServer: CRC check after download failed in memory range from 81000000H to 81004EEFH!
WARNING: Controller0.Core::UDEDebugServer: CRC check after download failed in memory range from 81004EF0H to 81004F0FH!
MSG: Controller0.Core::UDEDebugServer: Program with ID 0x1 - code size 20240 bytes - was loaded!

I don't know should I use JTAG or DAP? I set up DAS and Memtool only but I can't establish connection between PC and board like in the video so I cant't change flash memory and I can't do blinky. Should I set up another program from CD which is in the kit? Thank you for your advice.
0 Likes
5 Replies
Not applicable
Hi sumeyye,

check your DAS connection. Should be like in the attached screenshot.

Cheers, Martin
0 Likes
Not applicable
Martin firstly thank you for your reply. I checked all of these and my DAS connection is like you. There isn't any problem. But I run Memtool and I met this page;

2995.attach

I mean, except from UDE, flash is accesible. But in memtool page, I can't load program, how can I solve UDE problem? I changed some settings from menus but it doesn't work. Everytime like this;
2705.attach
0 Likes
User77504
Employee
Employee
10 sign-ins 5 sign-ins 5 replies posted
Hi sumeyye, I would recommend to contact the Free TriCore Entry Toolchain Support at tctcsupport@pls-mc.com. Regards Martin
0 Likes
Not applicable
Yes, I asked these questions to PDH and I'm waiting reply. Thanks again. Best regards.
0 Likes
User14560
Level 1
Level 1
Hi,

I am working on TC29X controller. Unfortunately boot mode headers are erased and I am unable to flash through lauterbcah. I am trying to use miniwiggler and I have connected target using 10 pin DAP connector to miniwiggler. But when I run DAS sevice scanner I see "No Device(DAS JDS miniWiggler V3.1)" message. Can anyone please help me ?

Thanks,
Gayathri
0 Likes