Not applicable
Mar 23, 2017
02:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 23, 2017
02:33 PM
Hi,
I see that P2.0 and P2.1 port pins are assigned for external oscillator and as well as they also assigned for alternate functions like for position detection channel in CCU6 timers in TLE9879xx board, but they are not in the port pins section. Can we solder two hall sensors signal pins out of three hall sensors for the BLDC motor control when we need to take use them as a CPOS (in CCU6) function?
please check the image I attached in this message.
I see that P2.0 and P2.1 port pins are assigned for external oscillator and as well as they also assigned for alternate functions like for position detection channel in CCU6 timers in TLE9879xx board, but they are not in the port pins section. Can we solder two hall sensors signal pins out of three hall sensors for the BLDC motor control when we need to take use them as a CPOS (in CCU6) function?
please check the image I attached in this message.
- Tags:
- IFX
0 Replies