Error occured while connecting to the solver process...PLS HELP!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Hello,

I'm pretty new to the Infineon Microcontroller Programming with DAVE.

Today I wanted to setup DAVE and start my 1st project with the XMC2GO.

I installed the 64-bit Version of DAVE and the Segger J-Link Drivers.

Unfortunately I get some error messages and I don't know what to do:

when i'm initializing a project, I always get the error: Error occured while connecting to the solver process.

This is causing following problem: when I want to work through this tutorial: http://www.infineon.com/dgdl/Infineon-DAVE_Quick_Start-GS-v02_00-EN.pdf?fileId=5546d4624cb7f111014d0...

I can't do the pin mapping part. All Pins of the µC are grey. And I can't even do this manual pin allocator. (screenshot attached)

3143.attach3144.attach


So I can't put the PWM Signal on a GPIO of the 2Go.

I uninstalled the 64-bit version and tried the 32-bit. Same Problem. Also uninstalled and reinstalled Dave+Apps+Segger J-Link multiple times. No change.

What is strange is, that I installed it on my other PC too, and there is no problem. the Pins are listed in the manual pin allocator and I can set the PWM Signal to the GPIO I want.

I didn't do anything different then on this PC.

Can anyone help me get DAVE running on my Laptop please?


Thanks in advance!
0 Likes
1 Reply
Not applicable
Hello Alibabara.

I got the same problem. I understand what you feel.

We better make a new forum other than this, because this forum is dead for a long time.

Even Lord Jesus's answer is not helping
https://www.infineonforums.com/threads/5194-Error-occured-while-connecting-to-the-solver-process?p=1...
2519.attach

By the way, have you find out the answer of your problem above? Because I still need the answer too
0 Likes