Not applicable
Feb 14, 2017
01:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 14, 2017
01:18 AM
Hi,
I am using KIT_AURIX_TC297 starter kit. I have connected it to my PC using JRAG interface.
I want to flash .hex file of my code to KIT_AURIX_TC297 starter kit using Infineon MemTool.
I am able to connect my board to the tool but the "Program" button is not activated. Thus, I am not able to flash my code.
I want to program PF0.
Is there any other setting which I am missing? Any hardware related setting for this?
Please reply and guide me.
Regards,
Divya
I am using KIT_AURIX_TC297 starter kit. I have connected it to my PC using JRAG interface.
I want to flash .hex file of my code to KIT_AURIX_TC297 starter kit using Infineon MemTool.
I am able to connect my board to the tool but the "Program" button is not activated. Thus, I am not able to flash my code.
I want to program PF0.
Is there any other setting which I am missing? Any hardware related setting for this?
Please reply and guide me.
Regards,
Divya
- Tags:
- IFX
1 Reply
Not applicable
Feb 15, 2017
08:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 15, 2017
08:51 AM
Assuming you've opened the .hex file successfully, are you able to select the sections you'd like to program (e.g. pressing Select All), and 'Add Sel >>' to add them to the list of things to program?
Can you Erase... successfully?
Can you Erase... successfully?