Tip of the day: Cannot change parameters using µC/Probe™ XMC™ GUI (iMotion™ MADK)

Announcements

From sunburn to sun earn – we’ve got the power! Watch our #poweringgreen videos now.

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
You bought one of the iMotion™ MADK kits based on XMC™ control card.
You have installed all necessary software and downloaded the firmware successfully.
Now you have started the µC/Probe™ XMC™ GUI correctly. But you cannot change the parameters given in the tab "PMSM_FOC_Parameters" or "Motor Tuning" even you confirm the input with "Enter".

Tip of the day:
This problem is caused by the Java cache.
Please make sure that you have the latest version of Java.
Then please delete the Java cache (Control Panel >> Java >> General >> Temporary Internet Files - Settings... >> Delete Files...).
Afterwards please reopen the µC/Probe™ XMC™ GUI and you will be able to change the parameters.

Best regards
Luxun Liu

--
Infineon iMOTION™ MADK support team
0 Likes
0 Replies