question about the multi-can analyzer mode of the XC2265!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
I tried to monitor CAN data by setting it to analyzer mode via "DAVE " tool.
But I could not find a way to receive data.

I want to receive CAN data through the following conditions.
1. that is set analyzer mode to node1
2. that is One network bus configuration with another CAN communication device.
3. that is Receive all data regardless of MO setting or Receive all data(another device).
* I want know CAN ID from some deviec by XC2000 MCU.

Please tell me how to set DAVE tool and how to use it.
Or application notes.
0 Likes
3 Replies
User22188
Level 1
Level 1
The XC2265 is a high-performance, multi-can analyzer that can measure up to 16 channels at the same time with an input frequency of 200kHz. This blog post will cover the basics of how to select and use this mode on your analyzer. Please note that all https://assignmentman.co.uk/ commands are in US English! The following video tutorial was created by Fluke Networks for more information about using this mode.
0 Likes

@User22188 wrote:
The XC2265 is a high-performance, multi-can analyzer that can measure up to 16 channels at the same time with an input frequency of 200kHz. This blog post will cover the basics of how to select and use this mode on your analyzer. Please note that all https://assignmentman.co.uk/ Tower Defense commands are in US English! The following video tutorial was created by Fluke Networks for more information about using this mode.

IC MCU 16BIT 100LQFP

0 Likes
mefenomo
Level 1
Level 1
First reply posted Welcome!
0 Likes