Not applicable
Oct 18, 2016
10:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 18, 2016
10:34 PM
Hi,
ERU will detect the HighZ->1 changes when programmed to catch rising edge?
If a GPIO pin programmed for input it is in HighZ?
So when I connect 5V to an input pin (with time controlled switch) and ERU programmed to detect rising edge, ERU will catch this change?
ERU will detect the HighZ->1 changes when programmed to catch rising edge?
If a GPIO pin programmed for input it is in HighZ?
So when I connect 5V to an input pin (with time controlled switch) and ERU programmed to detect rising edge, ERU will catch this change?
- Tags:
- IFX
1 Reply
Oct 19, 2016
06:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 19, 2016
06:06 AM
Hi
I would recommend to use the pull down in the input pin.
Regards,
Jesus
I would recommend to use the pull down in the input pin.
Regards,
Jesus