Not applicable
Sep 03, 2016
11:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 03, 2016
11:31 AM
Hi
My english is not so good, but I think that you will understand.
I have problem with xSPY when I want to see voltage signal. I use PMSMFOCSL01 control on XMC1300.
xSPY don't show the whole period so the signal look like that is cut and linearly connected with the beginning of the next period.
I think that problem is with buffer, maybe it is short and then information of variables are cut off. How to change when xSPY refresh buffer?
My english is not so good, but I think that you will understand.
I have problem with xSPY when I want to see voltage signal. I use PMSMFOCSL01 control on XMC1300.
xSPY don't show the whole period so the signal look like that is cut and linearly connected with the beginning of the next period.
I think that problem is with buffer, maybe it is short and then information of variables are cut off. How to change when xSPY refresh buffer?
1 Reply
Sep 05, 2016
11:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2016
11:45 PM
Hi,
The buffer size is fixed in xSPY. You could change the generated code, look at DBG002_Xspy.h definition of DBG002_PingPongBufType and definition of DBG002_STREAM_BUFF_LENGTH.
Give a try XMC ucProbe, which is the current supported tool.
Regards,
Jesus
The buffer size is fixed in xSPY. You could change the generated code, look at DBG002_Xspy.h definition of DBG002_PingPongBufType and definition of DBG002_STREAM_BUFF_LENGTH.
Give a try XMC ucProbe, which is the current supported tool.
Regards,
Jesus