Not applicable
Aug 23, 2016
11:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 23, 2016
11:45 PM
Hi,
I am working on XMC1100, While Sending Data Through the Terminal to xmc1100. Data Lost was happening. and the buffer full flag is enabled.
The UART Cofiguration as below
baudrate = 921600.
Rx = pin 1.1
Tx = pin 1.0
channel = U0C0
what might be the issue.
Thanks and Regards,
Harshan.
I am working on XMC1100, While Sending Data Through the Terminal to xmc1100. Data Lost was happening. and the buffer full flag is enabled.
The UART Cofiguration as below
baudrate = 921600.
Rx = pin 1.1
Tx = pin 1.0
channel = U0C0
what might be the issue.
Thanks and Regards,
Harshan.
1 Reply
Not applicable
Jun 22, 2018
11:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 22, 2018
11:07 PM
hello,
I am also having this issue on same device and configuration. I am using both channels.
Can anyone give solution?
Thanks.
I am also having this issue on same device and configuration. I am using both channels.
Can anyone give solution?
Thanks.