Not applicable
May 25, 2016
01:00 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 25, 2016
01:00 PM
Hi all,
I am having troubles figuring out how to use software triggers to request conversions with VADC on my XMC4400 micro. The reference manual states that there conversions may be requested by external signals (GPIO pins used for input), on-chip signals (e.g. PWM status bit) and software triggers. I can't seem to figure out how to trigger the request source with software? Which registers should I take a look at to figure this out?
Thank you!
Best regards,
Andrey
I am having troubles figuring out how to use software triggers to request conversions with VADC on my XMC4400 micro. The reference manual states that there conversions may be requested by external signals (GPIO pins used for input), on-chip signals (e.g. PWM status bit) and software triggers. I can't seem to figure out how to trigger the request source with software? Which registers should I take a look at to figure this out?
Thank you!
Best regards,
Andrey
2 Replies
Attachments are accessible only for community members.
May 26, 2016
07:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2016
07:24 PM
Not applicable
May 27, 2016
08:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2016
08:57 AM
Travis,
Thank you! This is exactly what I need.
Best regards,
Andrey
Thank you! This is exactly what I need.
Best regards,
Andrey