May 17, 2016
01:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2016
01:34 AM
Hello,
I selected the wrong BMI on a XMC1100 device. I have a 16 Pin microcontroller an selected the User Mode (Debug) SWD1 (SWDIO=P1.3, SWDCLK=P1.2).
But obvisouly this chip has no Port 1 (no PIN 1.2 or 1.3). I changed it with Dave 3.
Is it possible to change this back on SWD0 again or do i need a new chip ?
best regards
I selected the wrong BMI on a XMC1100 device. I have a 16 Pin microcontroller an selected the User Mode (Debug) SWD1 (SWDIO=P1.3, SWDCLK=P1.2).
But obvisouly this chip has no Port 1 (no PIN 1.2 or 1.3). I changed it with Dave 3.
Is it possible to change this back on SWD0 again or do i need a new chip ?
best regards
1 Reply
May 17, 2016
02:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2016
02:37 AM
Hello,
I guess there isn't any application code inside the chip that can change the BMI based on an external event?
In this case, I am afraid that you will need a new chip.
I don't think the chip can be connected to the DAVE tool anymore to allow the tool to change the BMI.
Regards,
Min Wei
I guess there isn't any application code inside the chip that can change the BMI based on an external event?
In this case, I am afraid that you will need a new chip.
I don't think the chip can be connected to the DAVE tool anymore to allow the tool to change the BMI.
Regards,
Min Wei