Apr 08, 2016
07:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 08, 2016
07:08 AM
Where in the reference manual to the XMC 4800, I can find the link between the pin (LED1 - P5.9 for example) and the IOCR register I have to use in order to configure the pin.
Any help?
Any help?
1 Reply
Apr 10, 2016
08:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 10, 2016
08:18 PM
Hello,
You can refer to page 2787 of the RM for the description on IOCR registers.
P5.9 is therefore controlled by P5_IOCR8 register.
This register contains the PCx fields for P5.8, P5.9, P5.10 and P5.11 (assuming all these pins are available).
Regards,
Min Wei
You can refer to page 2787 of the RM for the description on IOCR registers.
Register Pn_IOCR0 controls the Pn.[3:0] port lines
Register Pn_IOCR4 controls the Pn.[7:4] port lines
Register Pn_IOCR8 controls the Pn.[11:8] port lines
Register Pn_IOCR12 controls the Pn.[15:12] port lines
P5.9 is therefore controlled by P5_IOCR8 register.
This register contains the PCx fields for P5.8, P5.9, P5.10 and P5.11 (assuming all these pins are available).
Regards,
Min Wei