Not applicable
Mar 08, 2016
04:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 08, 2016
04:47 AM
Hi,
i'm trying to use the FATFS APP with the XMC1400 Boot Kit. I configured the SPI Master and soldered wires to a SD Slot including some Pullups (first only for MISO but i put some on MOSI, CS and the unused connectors -> same result, tried to use them as Pull-down as well).
I have an external Power supply for the card (but also tried to use the one on the board set to 3,3V). Everytime I try to mount the SD Card i get FR_NOT_READY. I tried it with 3 different (8, 16 and 32gb) and without a card with the same result.
The settings are set to default. I experimented with them but couldn't get it started.
Does anyone have an idea what the prolem could be?
regards
Bernni
i'm trying to use the FATFS APP with the XMC1400 Boot Kit. I configured the SPI Master and soldered wires to a SD Slot including some Pullups (first only for MISO but i put some on MOSI, CS and the unused connectors -> same result, tried to use them as Pull-down as well).
I have an external Power supply for the card (but also tried to use the one on the board set to 3,3V). Everytime I try to mount the SD Card i get FR_NOT_READY. I tried it with 3 different (8, 16 and 32gb) and without a card with the same result.
The settings are set to default. I experimented with them but couldn't get it started.
Does anyone have an idea what the prolem could be?
regards
Bernni
0 Replies