Attachments are accessible only for community members.
Not applicable
Feb 08, 2016
04:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 08, 2016
04:53 AM
Hello all.
I have an Easy kit_XC2331D-SK and I have tried to implement the the UART Data Transfer program with it. I want to transmit data from PC to micro controller and then send the received data to the PC to show it on a virtual screen by Proteus.
But unfortunately I did not receive any thing at the PC. I have used a uword variable in the keil which is named "value".
when I check the "value" variable in the keil, its content is continuously 0×0000 and it seems that the micro controller does not receive any data from PC.
I have attached the project file.
can any one help me to solve the problem?
Best Regards
I have an Easy kit_XC2331D-SK and I have tried to implement the the UART Data Transfer program with it. I want to transmit data from PC to micro controller and then send the received data to the PC to show it on a virtual screen by Proteus.
But unfortunately I did not receive any thing at the PC. I have used a uword variable in the keil which is named "value".
when I check the "value" variable in the keil, its content is continuously 0×0000 and it seems that the micro controller does not receive any data from PC.
I have attached the project file.
can any one help me to solve the problem?
Best Regards
- Tags:
- IFX
1 Reply
Not applicable
Feb 15, 2016
02:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 15, 2016
02:38 AM
Hello all.
I have solved the problem. The problem was due to difference between physical and virtual baud rate in Proteus ISIS.
When I set these two parameter to the same value, it have worked.
I have solved the problem. The problem was due to difference between physical and virtual baud rate in Proteus ISIS.
When I set these two parameter to the same value, it have worked.