Not applicable
Feb 02, 2016
04:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 02, 2016
04:24 AM
Hi All,
In the XMC1300 is it somehow possible to have the CCU8_PWM output going into the ERU with another signal to form a new signal? I have tried, but failed, now I have to output the PWM to a pin and then use it with another signal in the ERU. This just wastes 2 GPIO pins for nothing...
Regards
Enigma
In the XMC1300 is it somehow possible to have the CCU8_PWM output going into the ERU with another signal to form a new signal? I have tried, but failed, now I have to output the PWM to a pin and then use it with another signal in the ERU. This just wastes 2 GPIO pins for nothing...
Regards
Enigma
0 Replies