Not applicable
Jan 25, 2016
04:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 25, 2016
04:44 AM
Hi All,
I would like to generate dead time for the PWM app in DAVE 4, but I can not figure out how to do this in DAVE 4. The only information I can find about it, is in DAVE 3.
Can someone post some code, or just tell me how to do this please.
Regards
Enigma
I would like to generate dead time for the PWM app in DAVE 4, but I can not figure out how to do this in DAVE 4. The only information I can find about it, is in DAVE 3.
Can someone post some code, or just tell me how to do this please.
Regards
Enigma
1 Reply
Not applicable
Jan 26, 2016
09:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 26, 2016
09:15 PM
Hi Enigma,
PWM APP is meant to be a simple APP to generate a PWM using one timer slice of CCU4 or CCU8. Therefore, the dead-time feature is not supported.
For generating deadtime on the PWM, you can use PWM_CCU8 APP in the "Signal Settings" tab. Also, in the APP Help section "Usage", the usage of the PWM_CCU* is demonstrated.
Regards,
Daryl 🙂
PWM APP is meant to be a simple APP to generate a PWM using one timer slice of CCU4 or CCU8. Therefore, the dead-time feature is not supported.
For generating deadtime on the PWM, you can use PWM_CCU8 APP in the "Signal Settings" tab. Also, in the APP Help section "Usage", the usage of the PWM_CCU* is demonstrated.
Regards,
Daryl 🙂